TJ Series
The Original Full Tested and Approval Method for Effective Jointing of HT deformed Bars. Fast and Easy to Install
TJ Series
• Fast and simple on site installation
• No need for special trained site personnel
• Can be installed in awkward or limited
space situations
• Instant visual check of correct installation
• Failure load in excess of Fy in tensile and
compressive loading situations
Installation
• The coupler should be placed over the end existing rebar to a distance of half coupler length. All bolts are finger tightened into the sleeve and alignment checked and adjusted if necessary.
• The continuation bar end is placed into the coupler until it butts against the existing bar, and the remaining bolts are secured finger in position, again checking the alignment.
• The Jam bolts are fully tightened using ratchet wrench, torque value to recommended on the technical specification table.
